Perspective Article
El-Hussain I , Milad G Saad ,
Abstract
Seismic liquefaction is a serious geotechnical engineering problem that takes place in saturated cohesion less soils during earthquakes due to the increase of pore-pressure so that the soil shear strength is decreased to zero. Muscat is situated in the north-eastern part of Oman close to Oman Mountains, which witnessed four earthquakes of order of 5.2 magnitude in the last 1300 years. The surface geology of Muscat reveals great variety of hard rocks in the eastern, southern and western parts to dense and lose sediments in the middle and northern parts. Muscat Municipality provided 1082 borehole data to be examined for their liquefaction susceptibility based on the soil characteristics. Susceptible soils only are further considered to liquefaction hazard assessment. Liquefaction occurs during an earthquake if the cyclic stress ratio (CSR) caused by the earthquake is higher than the cyclic resistance ratio (CRR) of the soil. CSR values were evaluated using probabilistic peak ground acceleration (PGA) values for return period of 2475 years at the surface given by detailed hazard and micro zonation studies. CRR for Muscat region is conducted based on the borehole data with N values of SPT tests, and shear wave velocity results from 99 MASW surveys over the entire region. All the required corrections to get standardized (N1) 60 values, to correct shear-wave velocity, and scale the results for Mw 6.0 instead of the proposed 7.5 are conducted. Liquefaction hazard maps were created using the minimum factor of safety (FS) at each site as a representative of the FS against liquefaction at that location. Results indicate that under the current level of seismic hazard, liquefaction potential is possible at some sites along the northern coast, where alluvial soils, shallow ground water table, and relatively high ground motion are present. The expected settlement of the soft soil at each liquefiable site is also evaluated.