Short Communication
Das S, Talukder S, Solanki
Abstract
A washer is a thin plate with a hole that is normally used to distribute the load of a threaded fastener, such as a screw or nut. The washer used in automotive engine component is of split or spring lock washer. A ring split at one point and bent into helical shape. The benefit of spring lock washers lies in the trapezoidal shape of the washer. When compressed to loads near proof strength of the bolt, it will twist and flattern. This reduces the spring rate of the bolted joint which allows it to maintain more force under the same vibration levels. This prevents from loosening. The steel washer is one of the critical safety component for automobile engine and its failure may cause severe safety issue. Before subjecting to manufacturing the washer undergoes different process lines (Wire Rod → Drawing → Annealing → Pickling → Flattening → Spring Washer → Single Spring Washer). After manufacturing of washer toughness test is done to find out the metallurgical soundness and surface quality of the washer. In this toughness test the washer in a vice with the split ends free and straight above the vice jaws, a 90° segment of the free end is gripped with a wrench and bent. Washers should withstand twist test through a 90° angle without signs of fracture. The present paper highlights premature failure of automotive washer which failed during twist test. From the analysis, it has been observed that the distribution of spheroidized carbide is more uniform in good samples than that of rejected samples. Hardness profile variation was observed between good and bad spring samples. Overall investigation does not indicate any problem related to supplied wire rod material quality as no wire breakage problem observed. Inhomogeneous annealed structure in flat wire seems to result into variation in washer performance during twist test.